CROTCH ROPES

Nylon braided rope is best for crotch ropes. If you use cotton rope, apply it over nylon or silk panties otherwise the rope will abrade the skin and then your slave will get sore and you won't be able to have sex with them for several days. Putting knots in the crotch rope will not help unless the knots are perfectly placed, so you have to ask your slave how it feels when you're placing each knot.....

To make a crotch rope, you will need three 12-foot-long pieces of 5/16-inch rope. ....

1. Take the three ropes, find the middle of each, and hang them over your finger, with the midpoint of each rope over your finger.....
2. Grab the six ends, about seven inches from your finger, so you have a fist with three loops sticking out. ....
3. Run the ends so that they cross over the ropes, forming a loop.....
4. Reach through the loop and pull then ends through it. ....
5. Take a moment to groom the knot so that the ropes lie smoothly.....
6. Hold the knot in your right hand, with the loops pointing down, and arrange the six ends so that they are draped over your fist and evenly spaced.....
7. Stick out your index finger, and make sure that one strand is draped over it. Take this strand and, going counter-clockwise; lay it over the next strand. Take that strand, and again going counter clockwise, lay it over the next strand.....
8. Keep doing this till you have done all six strands. The last end goes through the loop around your index finger (from the first strand you worked with). The strand goes in the direction opposite to the way your index finger is pointing.....
9. Going counter-clockwise around the circle, gently pull on each strand, removing some slack. Don't try to remove it all at once, or you will pull the knot out of shape. Instead, go around the circle several times, taking out a little more slack each time. When you are done, you should have a symmetrical six-sided figure.....

Repeat the above procedure to make a second layer.....

10. Make a third layer. When you draw this one up tight, it will be snug forming a larger six-sided figure than before. Be sure to hold in place as you tighten them.....
11. Tighten up the layers more and more, until they are the same diameter as the first layer.....
12. Tighten up the braid a bit more using something like the end of a ballpoint pen (retracted, please), or a marlinspike, if you're really into knots, and starting at the bottom of the braid, pull out a loop of slack. Follow it up the braid, pulling out more and more slack, till you get to the top of the braided section. Pull on the appropriate end to remove the slack, and tighten up the top of the braid again. Do this for all six strands. Here is a tip for following the braid. As it goes from layer to layer, each rope forms a pattern like the letter "N", with the crossbar going under two other ropes. ....
13. Hold the braided section in your hand, so that you have two strands going to your left, two going to your right, and two hanging straight down.....
14. Take the left and right strands closest to the center, and cross the left one over the right one.....
15. Now take the left and right strands farthest from the center, and cross the left one over the right one, on top of the two you have just crossed.....
16. Of the two ropes still hanging down take the right-hand one, bring it up and cross it over to the left. Take the remaining rope, bring it up and cross it over to the right. Pull the braids tight.....
17. Take the outside rope on the right, and cross it over the others.Now take the outside rope on the left, and cross it over the others. Keep repeating this pattern. You will go from having three ropes on each side, to having four on one side and two on the other, then back to three on each side. Be sure to keep the braid tight; pull it snug after each left/right sequence. This forms a nice herringbone braid. (If you make one or two of the ropes a different color, you can get an interesting chevron pattern, too.)....
18. Braid until you are close to the end of the rope, then tie an overhand knot in it to keep it from unbraiding itself. I like to tie a separate overhand knot in the three ropes on each side. It is less bulky, and it keeps braid from being jumbled at the end.....
19. To use the crotch rope, you can tie a waist rope around your partner, running the waist rope through the loops on the crotch rope, or you can tie the loop to the waist rope with a short length of rope. Run the rope between the legs, and over the waist rope in back. If your slave is standing, you can unbraid the crotch rope to where it meets the waist rope, and tie a knot there. If she is lying on her back, it is better to run the end of the crotch rope over the waist rope, and back down between the legs. This causes less of an uncomfortable bump for her to lie on.....

Even so, you may have to put a pillow under her buttocks so she is not lying on the bump. With your partner lying on her back, you do not even need to tie the end of the crotch rope. The bumpiness of the braid, and the fact that she is lying on the waist rope, will hold it in place. You can pull on the end to tighten it up, and it will stay tight.....

Now, restrain your slave as desired....